Adjustment Of Geometry - Renault Clio Cup User Manual

2010 Release

4.3.3 ADJUSTMENT OF GEOMETRY

Body height
Body height is adjusted using the nut (1)
mounted on the extension (2).
Loosen the locknut (3).
Adjust body
loosening the nut.
Once the required height has been reached,
tighten the locknut.
Alignment and camber
The alignment and camber of the rear axle are
adjusted by inserting shims (1) between the
hub carrier and the axle.
Depending on the required effect, the shims
should be positioned according to the thickest
edge.
The correspondence between the shims and their resulting alignment/camber is given
in the following table.
No
77 11 160
shim
Camber -1,23
Alignment 0,21
To obtain the recommended setup (see 4-1 Setup) the following shim set should be
 Alignment (wheel opening): one 1° shim,
 Camber (wheel negative camber): one 1° shim.
Note:
height by tightening
Camber shim
10' 20'
77 11 160
176 175
-0,1 -0,19
0,03 0,05
used:
To achieve the same setting for both rear axle wheels, the shims used on
the left and right-hand sides may differ.
or
30' 1°
77 11 160 77 11 160
174 173
-0,29 -0,98
0,09 0,16
E-25
1
3
1
Alignment shim
10' 20'
77 11 160 77 11 160
172 171
-0,03 -0,05
-0,1 -0,19
2
30' 1°
77 11 160 77 11 160
170 169
-0,08 -0,17
-0,28 -0,84