Table of Contents
Advertisement
Figure 1.22
How to Insert a Micro floppy into a Mass Storage System
Mass Storage System
Back View
120V AC 50 60Hz
5A 250V FUSE
POWER
J19
Select
Position 1
When the micro floppy seats
properly into the access slot
this
indicator lights
green.
Label faces up
4.
Select position 1 of the POWER switch. If power is on, the POWER
indicator lights green. If power is not on, then refer to chapter 5 for
troubleshooting aids.
5.
Hold the micro-floppy with the labels facing up and the read/write access
slot nearest the drive.
ATTENTION: Do not insert the micro-floppy with its labels facing
down. Damage to the micro-floppy and loss of data can occur.
Appendix A
Care of Your Mass Storage System
Indicator lights green
11979
A 7
Advertisement
Table of Contents
