Avery Dennison Monarch 9860 Quick Reference page 5

Adjust the supply holder guides so the sides barely touch the roll. Make sure
5.
the supply roll turns freely.
Push down on the supply lever to unlock the supply guides.
6.
Lay the supply into the feed path. Tuck the supply under the nibs and in
7.
between the die cut sensor. Do not feed supply between the supply roller
and deflector.
For tags or labels, feed the supply between the upper and lower knife guides
8.
with at least 0.5 inches of supply through the knife.
Die Cut Sensor
Supply Le ver
For labels, your System Administrator should use cut mode 5 to cut in strips.
Refer to the Operator's Addendum for more information. There may be one or
two blank labels left between the printhead and knife after the last batch.
Nibs
3