Avery Dennison Monarch 9860 Quick Reference page 8

L o a d i n g R i b b o n
Open the cover.
1.
Unlock the printhead by turning
2.
the retaining latch.
Lift printhead assembly using the
3.
printhead tab until the assembly locks
into place.
Push the deflector tab down.
4.
Slide the extra ribbon core on
5.
the take-up reel as far as it will
go with the "This End Out" writing
facing out. Use your empty ribbon core
as the take-up core. The take-up core
only fits on the take-up reel one way.
Remove the new ribbon from the package. Do not wrinkle or crush the new
6.
ribbon.
Slide the ribbon onto the back reel as far as it will go. The ribbon roll only fits
7.
on the reel one way. Carefully unwind a few inches of ribbon from the bottom
of the roll.
Note: Make sure the "Monarch This
End Out" writing is facing out.
The ribbon roll only fits on the
reel one way.
Carefully feed the ribbon under
8.
both ribbon rollers and printhead.
Align the ribbon and make sure it is
9.
straight and centered throughout
the path.
Tape the ribbon to the take-up
10.
Do not tape the ribbon to the
take-up reel.
Rotate the ta
11.
Remove any slack in the ribbon by turning the take-up reel clo
12.
6
ke-up core until the leader is past the printhead.
core.
Printhead
Tab
Deflector
Tab
Take-up
Core
Take-up
Reel
Ribbon
Rollers
ckwise.