Omnia .11 Installation And Operation Manual page 75

If we did not tie them together, and there were multiple O11's on a network, the I/O board could get addresses from
th e wrong units and nothing would work.
A lso, the O11 could start handing out IP addresses to other devices on the network.
To exchange presets or IO configs between units, the web interface can be used for upload and dow
If you need a new card for a unit, it needs to contain a "firstboot" image (this requires the Ethernet cable to be
u nplugged for one boot while the processor board acquires the I/O board's MAC automatically).
A n existing card can be reset to the firstboot state by issuing the command reset_firstboot in an ssh session
P lease contact Omnia Support for assistance.
.
61
nload.