Limiters (Basic Tab); Limiters (Advanced Tab) - Omnia .11 Installation And Operation Manual

Limiters (Basic Tab)
There are 4 variable controls in the Limiters menu area and all of them are "global". That is, they affect all 6 limiter
bands simultaneously and equally.
Limiters Menu (Basic Tab)
Limiters (Advanced Tab)
Limiters Menu (Advanced Tab)
Lim Thresh (Limiter Threshold): This adjusts the threshold where audio peak limiting occurs over a + or – 6dB
range for each band. Lower settings will increase the amount of limiting and decrease the level going to the
following final limiter stages.
Conversely, higher settings will raise the limit threshold, causing less limiting but feeding more level into the
following final limiter stages.
The first global control is an overall Drive control
that allows you to adjust the amount of gain
reduction in the entire 6-Band Limiter section at
once. This is (conveniently) just like changing the
value of each control in the limiters crossover (XO)
by the same amount.
Next are Attack Time Offset, Release Time Offset
and Gate Threshold Offset controls. These can
adjust all 6 bands simultaneously relative to the
individual control settings in the Advanced tab.
Descriptions of the Attack, Release and Gate
functions are described in detail in the Advanced
tab section below.
Sub-Group controls for each AGC band become
available in the Advanced tab:
46