Chapter-3: Setting Up For Your System; Setup Mode; Network Parameter Setup - Omnia .11 Installation And Operation Manual

Stereo fm audio processor

Hide thumbs Also See for .11:

Table of Contents

Chapter-3: Setting Up for Your System

There are 3 setup/configuration screens in Setup mode: Network, Livewire and System configuration. The

currently running system software version can also be found in the System icon button.

Touch the Setup icon button icon in the upper-left corner of the screen to enter Setup mode.

You should see the following Network configuration screen. If not, touch the Network icon button to display it.

The Network setup screen is where you set up the Omnia.11's network parameters for remote control and/or

Livewire use. NOTE: A reboot will be required after changing any of the network parameters.

Available parameters are:

IP (IP Address)

Accepts data in the form of four octets to describe the Ipv4 network address assigned to

the Omnia.11's network interface. The entries have the form of:

[ octet] . [ octet] . [ octet ] . [ octet] which when entered may appear as a network address such as:

192.168.0.200

Table of Contents