9. Instructions for use
The first item displayed after
connecting the Programming Unit
PCT
UNIVERSAL
to the front of the transmodulator
is the Programming Unit's firmware
version:
A
B
C
PCT firmware
version
------------
V:5.03.00001
Sub-menu 1
Sub-menu 1
Sub-menu 2
Sub-menu 2
▲
▲
▼
▼
Sub-menu N
Sub-menu N
The configuration screens are organized in three
main sections as shown in the figure (refer to
Appendix 4 for a detailed diagram):
• Section A: MAIN MENUS
• Section B: CONFIGURATION MENUS
• Section C: MONITORING MENUS
LEDs A, B and C will light up indicating the currently
selected section.
The ■ button toggles between sections.
To move up and down a section press the ▲ and
▼ buttons .
To save data, press and hold the ■ button.
In each individual screen, pressing the
enables the "Edit mode" and the selected
parameter can then be modified by using the ▲ or
▼ buttons.
In those cases where the cursor may be placed
in more than one position (for example an input
Sub-menu 1
frequency with several digits) press the
many times as needed to position the cursor over
the desired field.
Sub-menu 2
To move to a different screen, press the
until the cursor stops blinking (cursor is OFF,
leaving "Edit mode").
▲
Each screen displays and allows the modification
of a single operating parameter, which is described
▼
by a short message on the display.
Sub-menu N
9.1 - MAIN menu (LED A is ON)
Transcoder selection
The first menu allows the selection of one of the
unit's tuners, A or B. Once selected, the remaining
submenus in this section will refer to the
parameters of the selected tuner.
SELECT
TRANSCODER
TUNER A
●
Press the
button to enter "Edit mode" so the last
line of the display starts to blink (cursor ON). You
can now select one of the tuners (A or B) using the
●
button
▲ and ▼ buttons. To exit "Edit Mode" press the
button until the cursor stops blinking (cursor OFF)
Satellite selection
●
button as
This menu only appears when transponder
mode has been selected in the corresponding
CONFIGURATION menu (see pag 20) and allows the
●
button
selection of one of the predefined satellites.
- TUNER
SELECT INPUT
The current list of pre-defined DISH NetworkTM
satellites is detailed in Appendix 3:
19
SELECT
TRANSCODER
TUNER A
●
A -
SATELLITE
61.5º EAST
EN