Televes HDTV TRANSMODULATOR - Dual 8PSK to QAM User Manual page 20

HDTV TRANSMODULATOR - Dual 8PSK to QAM
Slot E/W Sat ID
61.5º EAST DBS
72.7º EAST DBS
77º EAST DBS
110º WEST DBS
119º WEST DBS
129º WEST DBS
118.7º WEST Anik F3
121º WEST FSS 121
105º WEST FSS 105
Input frequency/transponder selection
Use this menu to select the input frequency, either
by entering the frequency value in MHz or the
transponder number, depending on the selected
mode (MANUAL, XPNDR STACK or XPNDR LEGACY).
The display will show the following information in
each case:
- TUNER A - - TUNER
SELECT INPUT SELECT INPUT
FREQUENCY TRANSPONDER
1500 MHz 1R= 974MHz
Press circle to enter the "Edit mode" and the last
line of the display will start to blink (cursor ON).
In manual mode (setting by frequency), you can
move the cursor to any of the 4 frequency digits by
●
pressing the button.
In transponder mode, the transponder's number
will blink displaying the corresponding L-Band
input frequency .
Input modulation selection
This menu only appears when the user has
selected the manual modulation mode in the
corresponding CONFIGURATION menu.
- TUNER
SELECT INPUT
MODULATION
TQPSK 7/8
In this case the user has to manually select the
input modulation, the available choices are:
QPSK Scan
A -
Input baud rate selection
This menu only appears when the user has
selected the manual modulation mode in the
corresponding CONFIGURATION menu. In this case
the user has to manually enter the baudrate of the
input signal (between 10,000 and 30,000 Kbaud).
A -
8PSK 2/3
8PSK 3/4
8PSK 4/5
8PSK 5/6
8PSK 8/9
TQPSK 1/2
TQPSK 2/3
TQPSK 3/4
TQPSK 5/6
TQPSK 7/8
- TUNER A -
SELECT INPUT
SYMBOL RATE
22.000 Kbaud
Output frequency/ channel selection
This menu allows the user to select the output
frequency/channel according to the mode selected
in the corresponding CONFIGURATION menu.
- TUNER A - - TUNER
SELECT OUT SELECT OUT
CHANNEL FREQUENCY
2 = 57MHz 57MHz (2)
In channel mode, the CATV QAM channel is
selected (see Appendix 1). The last line of the
display will show both the output channel number
and its center frequency (Channel # = center
frequency).
In frequency mode, the user can select any
frequency value between 57 and 999 MHz and
the corresponding channel number is displayed
between brackets.
The two outputs in an HDTV TRANSMODULATOR
- Dual 8PSK to QAM are completely agile, so the
two QAM channels can be positioned anywhere
in the spectrum allowing for maximum flexibility.
20
A -