Table of Contents
Advertisement
9
Once all modules are loaded, a pop up "Headend loaded!" will be displayed.
10
After exiting the CDC screen, all the recognized modules will be displayed.
You can double click on a module to monitor or configure it in the same was
as described in section "Using TSuite software in local mode, programming
modules one at a time".
Using TSuite software in remote mode, programming modules
through the CDC connected to the internet.
Preliminary considerations
1.
The connection between the CDC module and Internet can be
accomplished in two ways: through a LAN; or using the GPRS modem built
into a module ref. 555901. In the latter case, we need an active SIM card
with a data plan.
2.
If using a LAN, an internet connection is needed that does not block
outbound ports. The CDC will connect to a Televés server and this
connection
3.
will provide a link back to the CDC.
Steps to follow
1
In IP Connections, IP Connections management, select create new
connection, and select the Server option in the Connection Type. Then enter the
Name and the MAC Address of the module (found on the label).
2
In Session Control box, select IP Connection, then Start session. Then select
the name of the connection created in the previous step and enter the headend
password.
35
EN
Advertisement
Table of Contents
