enphase Envoy Installation And Operation Manual page 59

Message Shown on
Events and Inventory
Screens
Microinverter grid
configuration failure
cleared after xx attempts
Module Sleeping
No Grid Profile
Over Temperature
Power generation off by
command
Power On Reset
RGM Error
RGM Power Quality
Warning
Shutdown
Startup
Transient Grid Profile
59
Description
Description: A failed attempt to change the grid profile for the microinverters has
cleared. The grid profile was successfully applied.
xx = number of attempts
Recommended Action: No action is required.
Description: The microinverter is off for the night.
Recommended Action: No action is required.
Recommended Action: Ask the installer to use the Envoy Gateway interface to
select a grid profile for this system. For more information, see "Change or View the
Grid Profile" on page 41
Description: The Envoy has not been set up with a grid profile for the
microinverters.
Description: The microinverter is too hot and is not producing power. This very
rare condition usually clears without intervention.
Recommended Action: No action is required unless the condition persists. If it
persists, contact Enphase Energy customer support.
Description: The microinverter is not producing power by user command. This
uncommon condition will occur only during isolated troubleshooting procedures by
Enphase personnel.
Recommended Action: No action is required.
Description: The microinverter has powered on after having both AC and DC
disconnected.
Recommended Action: No action is required.
Description: The Enphase-compatible Revenue Grade Meter (RGM) has failed.
Recommended Action: Contact your installer to arrange for installation of a
replacement meter.
Description: The Enphase-compatible Revenue Grade Meter (RGM) reports that
the AC voltage coming from the utility is either too low or too high as specified by
applicable regional standards. This is usually a temporary condition that will clear
when power quality from the local utility returns to normal.
Recommended Action: No action is required unless the condition persists. If the
condition persists, contact your installer.
Description: The Envoy has been powered down (unplugged from AC power).
Recommended Action: Restore AC power to the Envoy.
Description: The Envoy has been powered back up (plugged back in to AC
power).
Recommended Action: No action is required.
Recommended Action: No action is required. This condition will clear once the
grid profile test is complete.
Description: This system is currently in test mode.
 2014 Enphase Energy Inc.
Envoy Installation and Operation
141-00011 Rev 05