Sub-Zero PRO 48 Use & Care Manual page 13

PRO 48 Use & Care
Cleaning
INTERIOR CLEANING
To clean interior surfaces and removable parts, wash with
a mild solution of soap and lukewarm water with a little
baking soda. Do not use vinegar. Rinse and dry thor-
oughly. Avoid getting water on lights, control center and
display panel.
Do not submerge or pour hot water over cold glass
shelves.
STAINLESS STEEL EXTERIOR
To clean the exterior stainless steel surfaces of the
PRO 48, use a soft, nonabrasive stainless steel cleaner
like Signature polish and apply with a soft lint-free cloth.
Signature polish is available from Signature Limited
Laboratory, P. O. Box 13436, Dayton, Ohio 45413, or call
877-376-5474.
To bring out the natural luster of the stainless steel, lightly
wipe the surface with a water-dampened microfiber cloth
followed by a dry polishing chamois. All work should
follow the grain direction of the finish. Better results are
obtained by keeping the cloth in continuous contact with
the stainless steel.
Do not use a metallic or highly abrasive cleaner or
cloth, as this will scratch the stainless steel finish.
CONDENSER CLEANING
The condenser of the PRO 48 is located behind the grille
at the top of the unit. Refer to the illustration below. The
grille must be lifted to access the condenser area for
cleaning. To lift the grille, pull out on the bottom edge of
the grille and tilt the grille frame forward.
Use a soft bristle brush and vacuum to remove dust and
lint from the condenser. Clean the condenser area every
three to six months.
Before cleaning the condenser, shut off power to the
unit at the control panel. Wear gloves to avoid injury
from sharp condenser fins.
Failure to clean the condenser could result in tempera-
ture loss or mechanical failure or damage.
CONDENSER
Location of condenser.
13
subzero.com