Table of Contents
Advertisement
iNSTALLiNg THE MAcHiNE
poSiTioNiNg THE MAcHiNE
When considering the location for the dishwasher, ensure
that there is adequate space to enable loading and
unloading of the dishes.
• D o not put your machine in any location where the
ambient temperature can fall below 5°C.
• B efore positioning, take the machine out of its
packaging by following the warnings located on
the package.
• P osition the machine close to a water tap and
drain. You need to site your machine, taking into
consideration that its connections will not be altered
once they are made.
• D o not grip the machine by its door or panel in order
to move it.
• T ake care to leave a certain clearance from all sides
of the machine so that you can comfortably move it
back and forth during cleaning.
• M ake sure that the water inlet and outlet hoses do
not get squeezed while positioning the machine.
Also, make sure that the machine does not stand on
the electrical cable. Adjust the machine's adjustable
feet so that it can stand level and balanced. Proper
positioning of the machine ensures problem-free
opening and closing of its door.
• I f the door of your machine does not close properly,
check if the machine is stable on the floor it stands on;
if not, adjust the adjustable feet and ensure its
stable position.
WATER coNNEcTioN
Be sure that the indoor plumbing is suitable for installing a
dishwasher. Also, we recommend that you fit a filter at the
entrance of your place or apartment so as to avoid any
damage to your machine because of any contamination
(sand, clay, rust etc) that might be occasionally carried in
through the main's water supply or the indoor plumbing,
and to forestall such complaints as yellowing and formation
of deposits after washing.
WATER iNLET HoSE
Do not use the water inlet hose of
your old machine, you must use
the new water inlet hose supplied
with your machine instead. Before
connecting the water inlet hose to
the water tap, ensure clean water is
flowing from the tap before making
the connection. Connect the water
inlet hose directly to the water inlet
tap. The pressure supplied by the tap
should be at a minimum of 0.03 MPa and at a maximum
of 1 MPa. If the water pressure is above 1 MPa, a
pressure-relief valve should be fitted in between.
After the connections are made, the tap should be turned
on fully and checked for water tightness. For the safety of
your machine, make sure to always turn off the water inlet
tap after each wash program is finished.
WARNING
WARNING
Note: Aquastop inlet hose has
components using 240V. Do not cut
Aquastop inlet hose. Do not let it get
folded or twisted.
WATER dRAiN HoSE
Remove
entire
internal
membrane
This connection should be at a minimum of 50 cm and at
a maximum of 110 cm above the base of the dishwasher.
WARNiNg: Maximum drain hose length is 4m. Longer hose
length will prevent correct drainingand result in poor wash
performance.
If you connect the water drain
hose to a trap spigot under
the sink, remove the plastic
membrane. If you do not
remove the entire membrane,
remaining food can cause
blockage in the drain hose
spigot. Ensure a hose clamp
is used to secure the hose to
the spigot.
The water drain hose can
be connected either directly
to the water drain hole or to
the sink outlet spigot. Using a
hose hook (if available), the
water can be drained directly
into the sink by positioning the
hose hook over the edge of
the sink.
9
INSTALLATIoN
Hide quick links:
Advertisement
Table of Contents
