Removal And Installation; Removal And Installation; General; Removal From Watercraft - Sea-doo SP 5876 Shop Manual

REMOVAL AND INSTALLATION

GENERAL

It is not necessary to remove engine from water-
craft for TOP END nor PTO FLYWHEEL AND
MAGNETO servicing. However engine removal is
necessary to repair BOTTOM END.
HX Model Only
Engine can be removed with jet pump in place. It
is not necessary to perform engine alignment
when engine support is not loosen from rubber
mounts. Engine rubber mounts sit on adapters
which can be loosen prior lifting engine. If an
engine rubber mount must be replaced, jet pump,
driveshafts and seal carrier have to be removed
and engine alignment performed.

REMOVAL FROM WATERCRAFT

All Models Except HX
In order to remove engine from watercraft pro-
ceed as follows.
-
CAUTION : Whenever removing engine
from watercraft, engine / jet pump align-
ment must be performed.
Jet Pump Removal
To withdraw jet pump unit ass'y, refer to PRO-
PULSION SYSTEM 09-01.
All Models
Electrical Connections
First, remove BLACK negative cable from battery,
then RED positive cable.
;
WARNING : Always disconnect starter or
battery cables exactly in the specified
order, BLACK negative cable first. It is recom-
mended to disconnect electrical connections
prior to disconnecting fuel lines.
All Models Except HX and XP
Remove battery holding straps and disconnect
vent tube from battery.
Remove battery.
Sous-section 01 (REMOVAL AND INSTALLATION)
All Models
Disconnect thermosensor wire and spark plug
cables.
Connect spark plug cables onto grounding device.
1
F01H27B
ALL MODELS EXCEPT XP
1. Magneto housing cover
2. Grounding device
3. Spark plug cables
F01D7MA
XP MODEL
1. Grounding device
www.SeaDooManuals.net
Section 04 ENGINE
2
1
1
3
04-01-1