Table of Contents
Advertisement
Apply Loctite 767 (antiseize lubri-
cant) (P/N 293 800 070) on spark plug
threads then reinstall them.
NOTE: After installation, ensure the
seal seats properly with the engine top
surface.
Reinstall ignition coils. Reconnect igni-
tion coil connectors.
To reinstall engine cover, remove dip-
stick, push engine cover downward
until it snaps.
Reinstall dipstick.
NOTE: It is recommended to fog the
engine valves with XP-S Lube (P/N 293
600 016). Contact your authorized
Sea-Doo Sport Boats dealer.
Exhaust System and
Intercooler Protection
The exhaust system is self draining,
but the intercooler (supercharged
models) and exhaust manifold need
to be properly drained to avoid dam-
age.
Using the flushing connector on jet
pump support, inject pressurized air
(around 689 kPa (100 PSI)) into system
until there is no more water flowing
from the jet pump.
smo2008-001-054_a
1. Flushing connector — location may differ
To ease the procedure, a custom hose
can be assembled. See the following
illustration.
smo2008-001-053_a
TYPICAL
1. Flushing connector adapter
(P/N 295 500 473)
2. Hose 12.7 mm (1/2 in)
3. Air hose male adapter
NOTICE
cooler and exhaust manifold may
cause severe damage to these com-
ponents.
Battery Removal and
Storage
For battery removal, cleaning and stor-
age, contact your authorized Sea-Doo
Sport Boats dealer.
Boat Cleaning and Repair
Wash the body and the trailer with
soap and water solution (only use mild
detergent).
fresh water. Remove any marine or-
ganisms from the hull.
NOTICE
fiberglass and plastic parts with
strong detergent, degreasing agent,
paint thinner, acetone, etc.
Stains may be removed from seats and
fiberglass with Knight's Spray-Nine or
the equivalent.
If repairs are needed to the body or
to the hull contact your authorized
Sea-Doo Sport Boats dealer. For paint
touch up to mechanical parts use BRP
spray paint. For minor gelcoat repairs,
a Gelcote
Gelcote International at www.gel-
cote.ca. Replace damaged labels/
decals.
Once boat is on trailer, unscrew the
drain plug, block the wheels and raise
the bow slightly with the trailer jack (if
so equipped) to allow water to drain.
Clean the bilge with hot water and de-
_______________
Failure to drain the inter-
Rinse thoroughly with
Never
clean
†
repair kit is available from
STORAGE
apparent
99
Advertisement
Table of Contents
