Assembly; Reverse Gate - Sea-doo SP 5876 Shop Manual

3
F02J06A
TYPICAL
1. Reverse support
2. Reverse cable
3. Triangular lever
6, Reverse Support
In order to have access to screw holding lower
part of reverse support, remove front seat by pull-
ing on each side to release it from body.
Remove screw, lock nut and washers holding
lower part of support.
Remove reverse cable from support.
Remove 2 Allen screws, lock nut and washer
holding guide plate and support.
1
2
3
F02J07A
TYPICAL
1. Guide plate
2. Allen screw
3. Screw and washer
1
2
www.SeaDooManuals.net
Section 09 PROPULSION SYSTEM
Sub-Section 03 (REVERSE SYSTEM)

7, Reverse Gate

Unhook reverse gate springs and remove ball joint
fasteners to release reverse cable from reverse
gate.
1
2
F02J08A
1. Reverse cable
2. Reverse gate spring (each side)
Unscrew reverse gate retaining screws from ven-
turi housing, then remove gate.
1
F02J09A
1. Screw (each side)

ASSEMBLY

Assembly is essentially the reverse of disassem-
bly procedures. However pay particular attention
to the following.
7, Reverse Gate
Install reverse gate with sleeve and washer. Ap-
ply Loctite 242 (blue) on threads and torque to 20
N•m (15 lbf•ft).
09-03-3