Table of Contents
Advertisement
STORAGE
lmr2010-017-003_a
1. Throttle accelerator sensors (TAS)
2. Wide open throttle position (WOT)
11. Turn ignition key to ON position.
NOTE: The ECM will allow engine
cranking while inhibiting fuel injection
and ignition. Do not crank engine for
more than 10 seconds.
12. Crank each engine a few turns to
distribute the oil on cylinder walls.
NOTE: Ask a person to assist you for
this operation.
13. Release TAS.
14. Turn ignition key OFF.
15. Apply LOCTITE 767 (ANTISEIZE
LUBRICANT) (P/N 293 800 070) on
spark plug threads then reinstall
them.
16. Reinstall ignition coils. Reconnect
ignition coil connectors.
NOTE: Prior to inserting the ignition
coils onto the spark plugs, apply some
DOW CORNING 111 (P/N 413 707
000) grease around the seal area that
touches the spark plug hole. After in-
stallation, ensure the seal seats prop-
erly with the top surface of the engine.
smr05-015-002_d
1. Apply product here
______________
122
17. To reinstall engine cover, remove
dipstick, push engine cover down-
ward until it snaps.
18. Reinstall dipstick.
NOTE: It is recommended to fog the
engine valves with XPS LUBE (P/N 293
600 016). Contact your authorized
Sea-Doo boats dealer.
Engine Coolant Test
If antifreeze is not replaced, test its
density.
The antifreeze replacement and a den-
sity test should be performed by an au-
thorized Sea-Doo boats dealer.
NOTE: Antifreeze of each engine
should be replaced every 200 hours
or every 2 years to prevent antifreeze
deterioration.
NOTICE
Improper antifreeze den-
sity may allow freezing of the liquid
in the cooling system if the boat is
stored in an area where the freezing
point is attained. This would seri-
ously damage the engine.
Battery Removal and
Storage
For battery removal, cleaning and stor-
age, contact your authorized Sea-Doo
boats dealer.
Boat Cleaning/Repair
Clean boat and trailer. Refer to
CARE
.
Replace damaged labels/decals.
If repairs are needed to the body or
to the hull contact your authorized
Sea-Doo boats dealer. For paint touch
up to mechanical parts use BRP spray
paint. For minor gelcoat repairs, a Gel-
cote repair kit is available from Gelcote
International at www.gelcote.com.
BOAT
Advertisement
Table of Contents
Troubleshooting
