Problems - Jura IMPRESSA 601 Instructions For Use Manual

CLEAN UNIT
UNIT CALCED
FAULT 2
FAULT 8

20. Problems

Problem
Coffee only flows in dribs
and drabs while drawing off
Coffee flow is stopped
after pre-brewing
Grinder is extremely noisy
Cause
You have drawn off coffee 220 times or run
the rinsing program 180 times
Message still displayed, although machine
cleaned
The espresso/coffee machine sector needs
decalcifying
Message still displayed, although machine
decalcified
Temperature too low
Initialisation problem
Cause
– Powder too fine
– Not enough coffee powder in the system
– Foreign element in grinder
Action
Clean as described in chapter 14
Run cleaning program again; this time do not
add cleaning tablet
Run decalcifying program as described in
chapter 15
Run cleaning program again; this time using water
only and without decalcifying agent
– Switch device off
– Leave device for approx. 2 hours at room
temperature
– Switch device on
Switch device off, disconnect from mains,
switch on
Action
– Adjust grinder to a coarser grinding
– Run the rinsing programme once or twice.
– If the problem persists, run cleaning programme
– Draw off one cup of coffee
– Proceed as described in chapter 13.5
E
21