Drawing Off Hot Milk Using The Auto-Cappuccinatore S9; Drawing Off Cappuccino Using; The Auto-Cappuccinatore S9; Controlling The Temperature Using The Auto-Cappuccinatore S9 - Jura IMPRESSA 601 Instructions For Use Manual

With the flow-adjustment you can set the optimum frothing.
Turn the handle slightly to the right or to the left until you
obtain the required result.
11.3 Drawing off hot milk using

the Auto-Cappuccinatore S9

The Auto-Cappuccinatore of the S9 can be used to draw off hot
milk. Adjust the selector lever (1) (Fig. 10) to position (3) to draw
off hot milk.
Install the Auto-Cappuccino. This is included in your
Welcome Pack.

11.4 Drawing off cappuccino using

the Auto-Cappuccintore S9
The Auto-Cappuccinatore of the S9 can be used to draw off capuc-
cino. Adjust the selector lever (1) (Fig. 10) to position (2) to draw
off capuccino.
11.5 Controlling the temperature using
the Auto-Cappuccinatore S9
Adjust the selector lever (1) to
less hot milk/cappuccino. Individual fine adjustment is possible.
11.6 Cleaning the Auto-Cappuccinatore
Remove Auto-Cappuccinatore (21). If you do not achieve
optimum results, disassemble the flow controller and the
selector lever (Fig. 10 for S9). Thoroughly rinse these parts
with water.
As soon as you have frothed enough milk, it is important to clean
the Auto-Cappuccino.
12
+
for hot milk/cappuccino or
Fill water in a jug and immerse the intake-tube in the water. Now
draw off steam until the water/steam mixture flowing into your cup
is completely clean. Your Auto-Cappuccino is clean again.

12. Switching off machine

When the machine is switched off, the rinsing program is auto-
matically run again. Therefore place an empty container under
the coffee-spout (15) and press ON/OFF key
water has run into the container, the machine powers down. Dis-
card the water.

13. Programming

Before leaving our factory, the machine is adjusted to enable you
to obtain coffee without any additional programming. In order to
adapt the result to your personal taste, various settings can be pro-
grammed individually. The programming keys are located behind
the front cover (3).
The following settings can be programmed:
Powder quantity
Coffee temperature
Water quantity
-
Steam portion
for
Tea portion
Filter
Water hardness
Economy mode
Timer clock
Automatic switch on time
Automatic switch off time
Supplies and cup counter
Language selection
. When the rinsing