Empty Grounds Container; Empty Drip Tray; Fill Beans; Removing Foreign Objects - Jura IMPRESSA 601 Instructions For Use Manual

14.2 Empty grounds container

Coffee grounds are collected in the grounds container.
EMPTY GROUNDS
If this message shows on the display no more coffee can be
drawn off. It is necessary to empty the grounds container.
Remove drip tray carefully as there is water in it.
Do not disconnect the machine from power socket while
you empty grounds.

14.3 Empty drip tray

EMPTY TRAY
If this message shows on the display no more coffee can be
drawn off. It is necessary to empty the drip tray.
Remove drip tray carefully as there is water in it.

14.4 Fill beans

FILL BEANS
Fill beans as described in chapter 3.3.
The message FILL BEANS will only disappear after drawing
off a coffee. We recommend cleaning the bean container
from time to time with a dry cloth before you refill beans.
Switch off the machine for this purpose.

14.5 Removing foreign objects

Switch off your machine by pressing ON/OFF key
Remove plug from power socket.
Open bean container (13) and remove the beans. The remaining
beans can be removed with a vacuum cleaner.
Loosen both screws in the bean container and then remove
container (Fig.5 + 6)
16
Remove any remaining beans with a vacuum cleaner.
Put the spanner on (Fig.7).
Now turn spanner anticlockwise until the foreign object loosens.
Remove remaining powder with a vacuum cleaner.
Replace bean container and fasten screws.

14.6 Clean machine

CLEAN UNIT
After coffee, etc., has been drawn off 220 times or after 180 rinsing
programs have been run, the machine must be cleaned. You can
continue to draw off coffee and hot water / steam. However we
recommend that you clean the machine (as described in chapter 14)
within the next few days.
CLEAN NOW
An acoustic signal indicates the need of an immediate cleaning.

14.7 Unit calcified

UNIT CALCED
The machine signals when decalcifying becomes necessary.
Under the correct implementation of Claris filter cartridges,
decalcifying of the machine becomes unnecessary. For
further indications read Chapter 7 "Use of Claris filter cart-
ridges".

14.8 Cleaning metal contacts

.
EMPTY TRAY / CLEAN CONTACTS
The remnants of the calcified deposits in the area of the metal
contacts must be removed. Proceed as follows:
Rinse fastenings in groove (B) as well as the metal contacts (A)
with hot water and some washing-up liquid. Then clean the
fastenings in groove (B) as well with a brush (Fig. 8).