Connecting An Ex2200 Switch To A Management Console Using Mini-Usb Type-B Console Port; Connecting An Ex Series Switch To A Modem; Figure 54: Connecting An Ex Series Switch Directly To A Management; Console - Juniper EX2200 Series Hardware Manual

Connecting an EX2200 Switch to a Management Console Using Mini-USB Type-B Console Port

Related
Documentation

Connecting an EX Series Switch to a Modem

Copyright © 2011, Juniper Networks, Inc.

Figure 54: Connecting an EX Series Switch Directly to a Management

Console

To Console port
(on the switch)
This section describes the process of connecting an EX2200-C switch to the management
console using the Mini-USB Type-B console port.
You can also configure and manage an EX2200-C switch using the RJ-45 console port.
By default, the RJ-45 port is set as an active console port and the Mini-USB Type-B port
is the passive console port.
Ensure that the USB to Serial driver is installed on the host machine. You can download
the driver from http://www.juniper.net/support/products/junos/dom/11.3/#sw
Ensure that you have the following parts and tools available:
1 mini-USB cable with Standard-A and Mini-USB Series B (5-pin) plugs (not provided).
To connect the switch to the console using Mini-USB Type-B console port:
Connect the Standard-A plug of the mini-USB cable to the host machine (PC or
1.
Laptop).
Connect the Mini-USB Series B (5-pin) plug of the mini-USB cable to the Mini-USB
2.
Type-B console port (labeled CON) on the switch.
Configuring the Console Port Type (CLI Procedure)
Connecting an EX Series Switch to a Network for Out-of-Band Management on page 113
Console Port Connector Pinout Information for an EX Series Switch on page 23
Cables Connecting the EX6200 Switch to Management Devices
Cables Connecting the EX8200 Switch to Management Devices
You can connect an EX Series switch to a modem through the console port on the switch.
Before you connect the switch to a modem:
Laptop CPU
Chapter 10: Connecting the Switch
.
117