Plymouth Pl4S Service Manual page 73

I
I
~
'
BODY
( 7) Hold the glass close to the wind-
shield opening and work the lip of the rubber
molding up and over the body edge (fig. 46).
( 8) Seal the rubber channel and glass
~ith "MoPar Windshield Sealer." Be sure
the compound goes along the edge of glass
between the glass and rubber, making a
water tight joint when the ruboer springs
back against the glass. Work a thin coating
of "MoPar Windshield Sealer" between the
outside of the body edge and rubber molding
to make a water tight joint at that point
(fig. 4 7). Also work the sealing compound
under the chrome strip.
( 9) Install the metal molding and clips
on front of windshield.
( 10) Using liquid soap around the rub-
ber molding, to prevent distortion of metal
molding, use a rubber mallet to install the
molding.
1938-39
( 1) Coat the edges of glass with a good
grade of soft soap, such as linseed oil soap or
its equivalent, containing no free alkali. Do
not use oil or grease.
( 2) Insert the glass
in
rubber molding
and roll the molding on glass. With both
glasses in place in molding, wind a strong
Figure 44-lnsta//ing Windshield Glass-Worl<ing
Rubber Molding Over Glass ( 1940·42 Models)
Figure 45-lnsta//ing Windshield Glass-Working
Upper Outside Corner of Molding Over Glass
( 1940-42 Models)
Figure 46-lnsta//ing Windshield Glass-Working
Lip of Rubber Molding over Body Edge
(1940-42 Models)
Figure 47-lnstal/ing Windshield Glass-Sealing
Rubber Molding to Body Edge
After
Windshield
Glass has been Installed (1940-42 Models)