Replacement Of Light Bulbs - Plymouth Pl4S Service Manual

~
I
LIGHTING AND WIRING 151
Figure .s-:Headlight Mounting Bolt (I)
( 1938 Model, Typical
of
1936-37 Models)
Figure 7-Removing Headlight
Door (1942
Model)
Figure 8-Removing Headlight Unit Retaining
Ring (1942 Model)
I
3. REPLACEMENT OF LIGHT Bl.lfLBS.
1942
( 1) Headlight. Remove the headlight
door ( f1g. 7). Remove the retaining ring
screws and withdraw the ring from the light
( flg. 8). Pull the sealed beam unit from the
retaining seats and pull the wire connector
straight off (fig. 9). After the new unit is
installed, aim the headlights.
( 2)
Parking Light. Remove the lims
retainer, lens and bulb.
( 3) Taillight. Reach inside the lug-
gage compartment, squeeze the socket re-
tainer and .Pull it out of its holder.
( 4) Stop Light. Remove the socket and
bulb from the underside of the deck lid to
replace the bulb.
1941
( 1)
Headlight. Remove the screw at
the bottom of the headlight rim, pull out-
ward at bottom and unhook the rim at the
top . ( flg. 1 0), Loosen the retaining ring
screws (fig. 11 ) and turn the ring to the left
to unhook it from the screws. Pull the sealed
1-Sealed beam unit
2-Sealed beam unit
mounting seat
3-Three-way cable
connector socket
4-Seoled beam unit
mounting seat spring
Figure 9-Removing Headlight Sealed Beam Unit
(1942 Model, Typical of 1940-41 Models)