(Cross And Roller Type) - Plymouth Pl4S Service Manual

I
T
UNIVER8AL JOINTS AND PROPELLER SHAFT
3. REPLACEMENT OF UNIVERSAL
JOINT BOOT (BALL AND TRUNNION).
1936-42--Cont'd
( 2)
-Leather Boot with Inner Seal ilt-
tached. The seams of seal and boot are per-
manently joined together when assembled
at the factory and this type can only be re-
placed after pressing the trunnion pin out of
the end of the propeller shaft.
1-Housing insulator 8-Housing
2-Housing bolt 9--lubricont fitting
211
( 3) Service Boot with Inner Boot Sep·
arate. This type boot can be replaced with-
out disassembling the universal joint. When
replacing the boot, be sure to remove all
traces of old boot, to insure a water-tight
joint. Place the inner boot in position (fig.
2) and secure with clips. Install the outer
boot and secure with clips (fig. 3 ) . Twist
wire very tightly on boot to prevent the
inner boot sliding over the rib on end of
the universal joint body. As the ends of the
wire are being twisted, tap wire with a rub-
ber or wooden mallet so that the wire sinks
into leather.
3-Housing bolt nut 10-Bearing snap ring
lockwasher 11-0il seal
4-Housing bolt nut 12-Fiange
5-Propeller shaft-front 13-Fiange washer
6-0il seal 14-Fiange nut
?-Bearing 15-Fionge nut cotter pin
Figure 8-Prope/ler Shaft Center Bearing
( 1940-41 Seven Passenger Models)
4. REPLACEMENT OF UNIVERSAl.
.......
JOINT (CROSS AND ROLLER TYPE).
1940-41-No adjustments are provided
to compensate for wear of any parts. Parts
which. show wear' must be replaced. The
cross roller bearing block and its component
parts form an assembly. (See figures 6 and
7). The cross roller bearing with its com-
ponent parts is also an assembly. When as-
sembling, lubricate all parts. If the splined
joint at the front of propeller shaft has been
disassembled, assemble with the balance
marking arrows mated as shown in figure 9.
Figure 9-Bo/ance Arrows (I) on Spline Joint
(Cross and Roller Type)
(1940-41
Seven Passenger Models)
legend for Figures 6 and 7-Propeller Shalt and Universal Joints
(Cross and Roller Type)
(1940-41
Seven Passenger Models)
1-Cross roller bushing
retainer
2-Cross assembly
3-Cross roller retainer
4-Spline yoke plug
5-Spline yoke oil seal
washer
6-Spline yoke oil seal 11-Cross roller dust seal 15-Spline yoke oil
7-Spline yoke lubricant 12-Spline yoke and seal cap
nipple plug assembly 16---Propeller shaft
8-Cross roller dust 17-Cross roller end
13-Cross roller bearing
seal retainer
9-Cross rollers
1 0-Cross roller and
bushing assembly
blOck retainer bearing block
assembly
18-Lockwasher
19-Screw
14-Cross roller bearing
block tie spring