Table of Contents
Advertisement
66
PLYMOUTH SERVICE MANUAL
13. REMOVAL OF REAR DOOR GLASS.
1940-42-cont'
d.
down, unlock the lower ends of the glass run
channel and remove the channel. Remove
the window regulator attaching studs and
lift the glass up and out of the door (fig. 29).
1936-39-Remove the trim panel. Run
the window all the way to the bottom. Pull
the glass run channel down and out of the
"U" clips at the top of the door. Run the glass
up while pulling outward at the top of the
glass, at the same time guiding the glass out
of run channel. Turn the regulator handle
until the lift arm is straight up, then lift the
glass and frame assembly out of the door.
14. REMOVAL OF REAR DOOR
WINDOW REGULATOR.
1936-42-Remove the inside door han-
dles, garnish molding, trim panel and door
glass. Remove the screws which hold the
regulator base to the door panel and remove
the regulator (fig. 30).
15. REMOVAL OF REAR DOOR LATCH
AND REMOTE CONTROL.
1940-42-Remove the door glass and
outside door handle. Remove the lower glass
run channel. Remove the screws ( 3, fig. 31)
and remove the assembly (fig. 32).
1939-Remove the garnish moldings
and trim panel. Remove the Jock plate
screws in the edge of door. Remove the
screws which hold the bracket to door panel.
Figure 30-Removing
Rear Door
Window
Regulator I I 942 Model)
Push the assembly downward and out
through opening in door panel.
1936-38-Remove the trim panel, glass
lift
regulator and outside door handle. Re-
move the lock plate screws and remote con-
trol plate screws ( 11, fig. 22 ). Push the lock
assembly toward the door hinges and lower
it out of the door.
16. REPLACEMENT OF REAR
QUARTER WINDOW.
1936-42-Remove the garnish molding.·
Push the glass and rubber weatherstrip to-
ward the inside of body. Using a wooden
wedge, force the rubber lip molding off the
metal edge of body opening. To install, seal
the rubber weatherstrip with "MoPar Wind-
shield Sealer," forcing the compound be-
tween the glass and rubber, making a water-
tight joint when the rubber springs back into
place. Insert a strong cord under the lip of
rubber seal and leave the ends hang out.
Force the glass and rubber assembly tightly
in place in body opening and pull the cord,
forcing the rubber molding in place. Install
the garnish molding.
1-Giass run channel fas·
3-Latch assembly fasten-
tening screws (upper)
ing screws
2-Giass run channel fas-
4-0utside door handle
tening screw holes
shaft retaining screw
(lower)
Figure 31-Removing Door Latoh Assembly
I
1940-42 Models)
Hide quick links:
Advertisement
Table of Contents
