Plymouth Pl4S Service Manual page 65

~I
~
I
BODY
63
Figure 18-Removing front Door Window Lift
Regulator-Second Position (1939 Model)
1--Giass run channel serrations 2-Stop
Figure 19-lnstalling front Door Window lilt
Regulator Stops on Glass Run Channel
(1939 Model)
stops to prevent rattles (fig. 20). Raise the
glass to within about 1 inch from the top of
the window opening and pull the glass
tightly into the rear run channel. If the glass
will not slide into proper position, loosen nut
( 2, fig. 21) on the adjusting bolt at bottom
of the regulator base while pulling the glass
toward the edge of door. With the glass in
position, tighten nut.
1936-38- Remove the inside door
handles, garnish molding, trim panel, glass
run (if front door) and glass. Remove the
·.-Bending lips of stop 2-Stop locked
Figure 20-Locking front Door Window Lift
Regulator Slops-First Type (1939 Model)
1-Regulator bose fastening screws
2-Adjusting bolt nut
Figure 21-Positioning Front Door Window in
Rear Run
Channel (1939 Model)
regulator stop and regulator mounting
screws (fig. 22 ). Pull the regulator down and
out through the opening in door panel (fig.
23 ). To install, loose11 nut ( 7, fig. 22) and
while the glass is up, press the glass tightly
against glass ~hannel in the lock side of the
door. Pound the glass into place with hand,
if necessary, but glass must be tight against
the latch side of door. While holding the glass
in place and straight up and down, tighten
the nut (7, fig. 22). Tighten the regulator
mounting screws ( 1-4, fig. 22 ).