Wifi Settings - American Dynamics Illustra Flex Series User Manual

3.2.4 WIFI Settings

Below settings control how this unit act in a wireless network. Users can connect to wireless networks and
enable wireless encryptions.
3.2.4.1 Basic settings

WIFI Function: Select "ON" to enable subsequent settings.

DHCP: The IP address is automatically obtained when "ON" selected; otherwise, select "OFF" to
manually setup the network setting.

IP Address: Manually input IP address when DHCP off selected.

Subnet Mask: Please use default address: 255.255.255.0. If subnet mask is not properly configured,
the unit may not be able to communicate with other devices.

Default Gateway: Leave blank as default setting. No Default Gateway address required if not used. Ask
your network administrator for further information.

Primary DNS: same as above.

Secondary DNS: same as above.
Note Please click "Save" button to save your settings. Users can click "Reset" to return last setting
and also click "Default" to set all the data and options back to defaults.
Please do not set your IP addresses of LAN and WIFI both in the same subnet in case
Caution
"unavailable to connect" message showing while networking with default IP address of the
unit.
F 3-34: WIFI B
IGURE ASIC
40
Illustra Flex Series 1MP Wireless Cube
S
ETTINGS