American Dynamics Illustra Flex Series User Manual page 7

Index # Name
1 WIFI antenna
2 MIC
3 Infrared LED*
4 Lens
5 Speaker
6 Default Button
7 Reset Button
8 RJ-45
Ethernet Connector
9 Power Terminal
10 Unit stand
11 LED Indicator
* D/N mode setting is auto. Cube network camera with IR ON will automatically switch to B/W mode when
the illumination is under a certain threshold.

Once wired networking is unavailable, please press and hold the default Button for 5
Note
seconds to restore the unit to factory default settings so you may reach the unit at its
default IP address for good. Please use Illustra Connect to find the IP address again.

If you want to use wireless network, you can press and hold Default (WPS) button a few
seconds to connect the network. The LED status will turn blue after WPS successful
connection. Otherwise, the blue light will always blink rapid. When WPS can't success
connection, please repeat the operation.
T 1-1: P I
ABLE ICTORIAL NDEX
Sending/receiving radio signals from computers or other WIFI
facilities for wireless communication
Audio IN
Illumination for night vision
Fixed lens
Audio OUT (Optional)

Resetting the unit to factory default (press and hold for 5
seconds)

This button also has WPS function. Please press this button
around 2 sec then WPS will be connecting.
Rebooting the system.
Wired network connection socket
Inlet for the power adaptor (DC 5V±10%, 1.5A)
The unit's body support
Red Light On Wired Network Ready With Networking
Red Light Blinks Wired Network Ready Without Networking


Blue Light On

Wireless Network Ready Without Networking and
Blue Light Blinks
AP connection
Blue Light Blinks
WPS ready without networking
Rapid
7
Illustra Flex Series 1MP Wireless Cube
D
EFINITION
Description
Wireless Network Ready With Networking
and AP connection
When ad hoc of WIFI mode is enabled and
networking, the blue light will turn on.
WPS ready and connection