Dry Ironing - Russell Hobbs 12290 Instructions And Warranty


Pilot light will switch off, when the required temperature has been reached.

Turn the Steam Control/Self-Cleaning Knob to
come out from the vents on the sole plate.

Begin first time ironing with an old towel.

When the water tank is empty and no more steam can be produced; the
preparation work is complete. The iron is ready for proper use.
USING SPRAY FUNCTION

This function can be used at any time and it does not affect other functions

Fill the iron as described in the section of Filling the iron with water

Aim the nozzle to the garment.

Press the Spray Button.

NOTE: It may be necessary to press the spray button a few times to start the
function.

DRY IRONING


Connect the iron with a suitable mains supply outlet, pilot light will glow for a
second then switch off.

Move the steam control knob to

Turn the temperature dial in a clockwise direction, select
' (
or ' 3 dots) or to MAX position according to the garment label
recommendations.

Pilot light will glow to indicate that the iron is heating up.

When the required temperature has been reached, the pilot light will switch off.

The iron is now ready to use.

After use, make sure to turn the temperature dial anti-clockwise to the „MIN‟
position, the iron is then switched off.

Disconnect the iron from the mains supply outlet.

When the iron gets cool completely, store it vertically in a safe place.
position; steam will start to

'
6

' (1 dot), ' ' (2 dots)