Table of Contents
Advertisement
l
DRY IRONING
If you are going to be dry ironing only, there is no need to fill the water tank.
•
Move the steam control to
•
Set the temperature control dial to the desired setting.
•
Wait until the light switches off, then commence ironing.
VERTICAL STEAM
Vertical steaming removes wrinkles from hanging clothes,
hanging curtains, and furnishing fabrics.
•
Check that there is water in the tank.
•
Turn the temperature control dial to 'max'.
•
Wait until the light switches off.
•
Check that there is nothing behind the fabric that may be
damaged by the steam or heat.
•
Check that pockets, turn-ups and cuffs are empty.
•
Hold the iron, with the soleplate vertical, close to (but not
touching) the fabric.
•
Press the
burst of steam button. You may have to press it 2 or 3 times to pump water
through the system.
•
Leave 3 seconds between bursts to allow the temperature to recover.
AFTER USE AND STORING
•
Turn the temperature control dial to 'nylon', move the
steam control to
•
Unplug the iron.
•
Lift the cover of the water inlet to the top to open it.
•
Hold the iron over a sink, turn it upside down, and drain the
water from the tank.
CAUTION: The water may be hot.
•
Sit the iron on its heel.
•
Leave it to cool down completely.
•
When it is cold, wipe off any moisture, and close the water
inlet cover.
•
The cord can be wrapped around the heel of your iron for storing. Insert the plug into the plug
storage receptacle and wind towards the right to secure the last section of cord as shown.
•
Store the iron on its heel, to avoid corrosion and damage to the soleplate.
no steam.
m
no steam.
max
max
6
H B
i
e
k
j
l
o
g
m
Advertisement
Table of Contents
