Steam Ironing; Shot Of Steam; Dry Ironing; Vertical Steaming - Russell Hobbs 20562-56 Instructions Manual

h STEAM IRONING
23 If you intend to use steam, the temperature setting must be S or higher.
24 Set the steam control to the setting you want (S = no steam, # = high).
25 Wait till the light goes off, then start ironing.
k SPRAY
, Water spotting affects some fabrics. Test this on a hidden part of the fabric.
26 Lift the iron off the fabric.
27 Aim the spray nozzle at the fabric.
28 Press the * button.
29 You may have to press it 2 or 3 times to pump water through the system.
i SHOT OF STEAM
30 If you intend to use steam, the temperature setting must be S or higher.
31 Lift the iron off the fabric.
32 Press the ~ button.
33 You may have to press it 2 or 3 times to pump water through the system.
34 Leave 4 seconds between shots, to let the steam build up.
n DRY IRONING
, If you're going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid
spontaneous bursts of steam.
35 Set the steam control to S.
36 Wait till the light goes off, then start ironing.
l VERTICAL STEAMING
37 Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
38 Check that there is adequate ventilation behind the fabric, otherwise moisture may build up,
causing mildew.
39 Check that there is nothing behind the fabric that may be damaged by the steam.
40 Check that pockets, turn-ups, and cuffs are empty.
41 Set the temperature control to max. Set the steam control to S.
42 Lift the iron off the fabric.
43 Press the ~ button.
44 You may have to press it 2 or 3 times to pump water through the system.
45 Leave 4 seconds between shots, to let the steam build up.
C AFTER USE
46 Set the temperature control to •. Set the steam control to S.
47 Unplug the appliance.
48 Open the cover.
49 Hold it over a sink, turn it upside down, and drain the water from the reservoir, via the water
inlet.
50 Close the cover.
51 Sit the iron on its heel.
52 Leave it to cool down completely.
53 When it's cold, wipe off any moisture, and wind the cable round the heel.
54 Clean the outside surfaces of the appliance with a damp cloth.
55 Remove spots from the soleplate with a little vinegar.
56 Store the iron on its heel, to avoid corrosion and damage to the soleplate.
4