Using Your Iron For The First Time - Russell Hobbs 12290 Instructions And Warranty

FILL THE IRON WITH WATER:

Disconnect the iron from the mains supply outlet.

Move the Steam Control Knob to

Open the water inlet cover as in Fig2.

Hold the Iron with the heel uppermost and pour water up to the maximum level
as in Fig3.

Close the water inlet cover and wipe up any spillages on Iron.

NOTE: For the best results, it is advisable to use de-mineralized water or distilled
water.

Do not use chemically de-scaled water or any other liquids.
FIGURE 2
`

USING YOUR IRON FOR THE FIRST TIME


Remove any protective films or stickers from the sole plate and the iron body.

Unwind and straighten the power cord.

Fill the iron as described in the section of Fill the iron with water.

Connect the iron to a suitable mains supply outlet; the pilot light will glow for a
second then it will switch off.

Turn the temperature dial in a clockwise direction to the 'MAX' position; Pilot light
will glow to indicate that the iron is heating up.
position.
FIGURE
5
3