Cisco TelePresence System EX90 installation guide 78-19788-03 EX90 Installation Guide | April 2012 | © 2010-2012 Cisco Systems, Inc. All rights reserved.
AC adapter and power cable • Ethernet cable User documentation User guides and compliance and safety information for this product are available at the Cisco web site: http://www.cisco.com/go/ex-docs Unpacking the touch screen and cables Lift the rectangular box out of the package.
Unpacking the EX90 unit Lay the package flat on the floor. Pull the EX90, surrounded by foam protection, out of the package. Carefully loosen the foam protection. Lift the EX90 and place it on a firm surface. Weight: 14 kg / 31 lb EX90...
Optional: Mounting the handset Tool: Screwdriver Hold the touch screen and the handset Fasten the two units together. The screws base in an upright position. are pre–mounted in the handset base. Move the two units together. Make sure the Use the screwdriver and fasten the screws at the connector on the handset base slides into the handset base from the underneath.
System overview and basic setup Remove the cover to get access to the connectors at the rear side. You may connect an external microphone and a headset to your system (not provided). Kensington lock Micro- Headset 2 x USB phone Connect the touch screen, Scale 1 LAN and power as illustrated.
• Tap the power button once to switch on/ Please read the user documentation, off the monitor. which is available on the Cisco web • Press gently and hold the power button site, for further information about to shut down the system.