Run-Log - Thermo Scientific FOCUS GC Instruction Manual

Chapter 2
The FOCUS GC User Interface
Parameter
From 0 to 3 for Det range
Setpoint
On/Off for EV
---
Next event
1. Parameters available only with the TCD detector
To program a Run Time Event, refer to Chapter 11

Run-Log

This function displays the run log, which records errors or method changes that
happen in run time. It display the time and describes any deviation that occur.
This information is used to meet good laboratory practice (GLP) standards.
For example, if you interrupt the run for any reason, the run log will record the
time the run stopped and a description of the event. The Run-log is cleared and
reset at the beginning of the next run.
Run log entries are shown pressing the
To see the details Run-Log entries, in Main Menu move the cursor until the
Others
An example of Run-log is shown below.
64
Table 2-14. Edit Time Event Menu (Continued)
Range
Select the correct setpoint according to the event
you have set in the previous line. This line doesn't
appear for Det autozero.
Add a new event
page is selected, then press ENTER. Scroll to

Run-log

Description
Getting
key.
STATUS
Run-log
OTHERS
Run-Log
Started.
then press ENTER
Instruction Manual