IBM SAN384B Installation, Service And User Manual page 54

Figure 13. Chassis half way into cabinet on load plate
10. Release the spring-loaded pins under the load plate, and slide the middle
11. Lower the lift plate to its lowest position, release the wheel brake on the lift
12. If necessary, adjust the rubber strips on the exhaust kit duct to ensure a good
13. The chassis will be secured to the cabinet with six 10-32 screws with washers
26
SAN384B Installation, Service, and User Guide
Note: For rails with round holes, use the clip nuts (F in Figure 6 on page 19)
on the rails for securing the 10-32 screws. For rails with square holes,
use the retainer nuts (G Figure 6 on page 19). Also refer to Figure 7 on
page 21.
section of the load plate back into load plate.
tool, and move the lift tool away from the cabinet.
seal against the chassis.
(see Figure 14 on page 27). Four of these screws will also be used to attach the
cable management finger assemblies. Do not install the screws until you
determine the position of the cable management fingers.
Note: Screws, clip nuts, and retainer nuts to secure the chassis to the cabinet
are provided in the SAN384B hardware accessory kit.