IBM SAN384B Installation, Service And User Manual page 50

Figure 8. Shelf installed in cabinet
5. Install the air-duct assembly (B in Figure 6 on page 19) by inserting it down
Figure 9. Air duct installed into side slot in shelf
6. Attach the top-rail assembly (A in Figure 6 on page 19) to the air-duct assembly.
22
SAN384B Installation, Service, and User Guide
Tighten the four 6-32 screws on the top of the shelf, which were loosened
d.
to adjust the shelf length.
into the side slot on left side of the shelf (see Figure 9). Ensure that the tabs of
the duct align and engage with the slots in the shelf, with the open side of the
duct facing towards the center of the cabinet.
a. The top-rail assembly can be adjusted to a length of between 27 and 31
inches (68.58 to 78.74 cm) to fit on the inside of the cabinet rails. To lengthen
or shorten the top-rail assembly, loosen, by approximately 1/2 turn, the two
Port Side
(Exhaust)
384b034
384b036