Table of Contents
Advertisement
Torque requirements
Use the following torque settings when tightening screws that secure the port-side
exhaust kit and SAN384B to the equipment cabinet.
Installing the exhaust kit hardware
1. Remove the rear door (exhaust side) from the C36 cabinet. Set the door aside,
2. The exhaust side of the port side exhaust kit will be installed facing the rear of
3. Install 10 clip nuts (F in Figure 6 on page 19) or retainer nuts (G) in the rear
20
SAN384B Installation, Service, and User Guide
Table 6. Torque requirements for mounting screws
Screw size
6-32 x .25 in. (.635 cm) Phillips screw
10-32 x .63 in.(1.60 cm) Phillips screw
away from the installation.
the C36 cabinet, and the port side of the SAN384B chassis will also face this
direction.
vertical cabinet rail locations shown in Figure 7 on page 21, and 4 clip nuts or
retainer nuts in the front vertical cabinet rails. Eight clip nuts and retainer nuts
are provided with the exhaust kit, and six are provided with the hardware
accessory kit. Install the lower two nuts at the same relative locations on all
four cabinet vertical rails, to provide a level mounting of the shelf. The fourteen
nuts will secure the eight 10-32 screws that mount the port side exhaust kit
shelf (position 23 in Figure 7 on page 21) and the six that are used to attach the
SAN384B chassis to the cabinet (positions 25, 28, and 30 in Figure 7 on page
21).
Note: For rails with round holes, use clip nuts. For rails with square holes, use
retainer nuts. Figure 7 on page 21 is only an example showing relative
positions for these nuts in the cabinet rails to mount the shelf and
chassis. You can mount the shelf and chassis in 9 U of cabinet space
higher or lower in the cabinet than shown.
Note: Screws, clip nuts, and retainer nuts for attaching the SAN384B to the
cabinet are provided in the SAN384B hardware accessory kit.
Torque
8.75 in.-lbs (10 cm-kg)
32 in.-lbs (36.86 cm-kg)
Advertisement
Table of Contents
Troubleshooting
