Unpacking The San384B - IBM SAN384B Installation, Service And User Manual

10. The lift plate has a middle section that can be extended to the right (when
11. Move the assembled lift tool and retention straps near the equipment to be
Figure 4. Assembled lift tool with 24-inch load plate

Unpacking the SAN384B

To unpack the SAN384B, follow these steps:
16
SAN384B Installation, Service, and User Guide
7. Attach the 24-inch load plate, by slipping the top curved portion under the
horizontal bar, and resting the load plate on the forks.
8. Attach the anti-tip bars (recommended to provide additional stability when
the loaded lift tool is raised more than 45 cm (18 in) high). Install these from
the rear of the lift tool, by sliding them inside the horizontal legs, pulling up
on the leg lock pins to allow the pins to engage the holes in the legs and the
anti-tip bars.
9. Secure the anti-tip brackets to the lift tool with the supplied brackets and
bolts.
viewed from the back of the lift tool). This middle section is secured in place
by two spring-loaded pins. Familiarize yourself with releasing the pins and
sliding this section. There are two stops: half-way extended and fully
extended. This middle section will need to be fully extended during the
installation to safely span the gap between the lift tool and the cabinet
mounting position.
installed. Figure 4 shows the assembled lift tool with the 24-inch load plate
installed.
CAUTION:
The weight of this part or unit is more than 55 kg (121.2 lb). It
takes specially trained persons with a lifting device to safely lift
this part or unit. (C011)
55 kg ( 121.2 lbs)