Recording; Maintenance; Upgrading Redmote Firmware - Red Epic Epic-X Operation Manual

RECORDING

IMPORTANT: Before recording from a REDmote ensure the camera is properly powered, set up
and media is connected. Refer to BASIC OPERATION.
To record, press the Red REC (record) button on the REDmote (or any of the other available record
buttons).
•
If media is connected and properly formatted, the upper LED will illuminate Red and the Timecode
text will change to Red.
•
If media is NOT connected, the REDmote and camera LCD will indicate "NO MEDIA ATTACHED".
To stop recording, press the record button a second time.

MAINTENANCE

UPGRADING REDMOTE FIRMWARE

The REDmote Update program allows you to upgrade the firmware on your REDmote.
NOTE: Once firmware is upgraded (on REDmote or camera) the REDmote must be paired to the
camera again.
IMPORTANT: After upgrading your REDmote firmware to v1.0.13, you CANNOT roll back the
firmware to lower than v771.
188 188
©2011 RED.COM INC.
Version 2.0.5R1
DECEMBER 20, 2011