Heating Modes; Standard Mode (Factory Default); Economy Mode; Selecting Standard Or Economy Mode - Sundance Spas Altamar Owner's Manual

11.0 Heating Modes

The control system in your hot tub activates a programmable "standard"
or "economy" mode which effects when the heater operates. Refer to
sections 11.1 and 11.2 below for additional information.

11.1 Standard Mode (Factory Default)

Standard mode is typically selected by customers in cold climates where
heat up times are extended due to lower ambient temperatures. In this
mode, water temperature is regulated by the set temperature which acti-
vates the heater automatically as needed.

11.2 Economy Mode

Economy mode is typically selected by customers in warm climates
where heat up times are minimized due to higher ambient temperatures.
In this mode, the water temperature is regulated by the set temperature
only when a programmed filter cycle is running, unless in summer logic
(page 50).

11.3 Selecting Standard or Economy Mode

Press the (MODE) button to select either "Standard" or "Economy"
mode. The control panel's indicator on the right side of the LCD changes
to indicate which mode is selected. Note: "Standard" is shown when
Standard Mode is selected; No display is shown when economy mode is
selected.

11.4 Clean-Up "Blow-Out" Cycle

The clean-up cycle is once per day in both Standard and Economy
modes at 12:00 (noon) for two minutes. This is not user programmable.
Jets pump 2 (and Maxxus jets pump 3) activate for one minute to circulate
any water in the plumbing. After 1 minute they both go off and jets pump
1 turns on, runs for 1 minute, then shuts off.
Page 48