Troubleshooting - Display Messages - Sundance Spas Altamar Owner's Manual

If your stainless handrails shows signs of rusting you should:
• Wash with fresh water (a good detergent won't hurt).
• Clean with a good car chrome polish.
• Wax with an automotive or fiberglass wax.
You should never:
• Clean with chlorinated cleaners or scouring powders.
• Use sand paper, "Scotch Brite", Brillo pads, or similar abrasive
products.
• Clean with muratic or hydrochloric acids. Vinegar is ok, but it won't
do much to remove rust.

15.0 Troubleshooting - Display Messages

There are a number of unique functions designed into your Sundance hot
tub to protect it from damage and/or to aid in troubleshooting. Following
is a listing of all the possible messages along with their meanings:
MESSAGE
* *
MEANING
Overheat Protection (Heater is deactivated, filter/
circulation pump is activated). Water temperature is
above acceptable limits. Do not enter the water!
Remove hot tub cover to speed cooling. See
"Water is too hot" (page 64). If condition persists,
contact your authorized dealer or qualified service
technician.
If the hot tub water is more than 20 °F cooler than
the temperature setpoint, jets pump #1 and heater
will automatically activate to provide freeze
protection. The hot tub will stay in this mode until
the water temperature reaches 15 degrees below
the set temperature. No corrective action is neces-
sary.
FLOW SWITCH (Heater is deactivated. The filter/
circulation may also be deactivated). Proper flow
of water is inhibited or a flow switch has malfunc-
tioned. Check for proper water level and for
clogged filter (page 54-55). Contact your autho-
rized dealer or qualified service technician.
Page 61