Sundance Spas Altamar Owner's Manual page 70

Pump Priming Instructions:
1. Turn off power to the hot tub.
2. Remove the handle from the massage selector supplied by the
pump you are priming.
3. Loosen the massage selector's cap slightly (counterclockwise),
listening for the air to seep out.
4. Tighten the cap finger-tight, replace the handle and turn the hot
tub's power back on.
Note: This method must be used for the jets pumps because these
pumps are not connected to the main filter system in any way.
IMPORTANT: If freezing convditions exist and pump is not opera-
tional, take measures to protect the system from freeze damage. See
section titled "Winterizing", page 58.
POOR JET ACTION
(see Fig. G-M, page
22-28)
WATER IS TOO HOT
NO HEAT
FILTER/CIRCULATION
PUMP OFF
Page 64
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (page 54-55).
1. Reduce thermostat setting (page 16).
2. Switch hot tub to "Economy" mode to turn
heater on only during programmed filter
cycles (page 48).
1. Check thermostat setting.
2. keep the cover in place while heating.
3. If "heater on" indicator is lit (page 21) but
no temperature rise is experienced after
a reasonable period of time, contact your
authorized dealer or qualified service
technician.
1. Verify filter/circulation pump is programmed
to run 24-hours a day (page 49).
2. Filter/circulation pump cycle canceled by
power interruption. Wait 24-hours for hot