Without Circulation Pump Option; With Circulation Pump Option; Economy Filtration/Heating Modes (All Models); Lock Modes - All Models (L1 - L2) - Sundance Spas Hawthorne Owenrs Manual

10.1 Standard Filtration/Heating Modes For Models without
Circulation Pump Option
Standard filtration/heating modes (F1-F3) are typically selected by cus-
tomers in cold climates where heat up times are extended due to lower
ambient temperatures. In either of these modes, the water temperature
is regulated by the set temperature, low-speed jets pump 1 and heater
which turns on as needed. After the programmed set temperature is
reached, the heater and low speed pump turn off, only to turn back on
during a heat call or during the next programmed filtration/heating cycle.
10.2 Standard Filtration/Heating Modes For Models with
Circulation Pump Option
Standard filtration/heating modes (F0-F3) are typically selected by cus-
tomers in cold climates where heat up times are extended due to lower
ambient temperatures. In either of these modes, the water temperature
is regulated by the set temperature, 24-hour circulation pump and heater
which turns on as needed. After the programmed set temperature is
reached, the heater turns off and the circulation pump continues to oper-
ate 24-hours to filter and clean your spa.

10.3 Economy Filtration/Heating Modes (All Models)

Economy filtration/heating modes (F4-F6) are typically selected by
customers in warm climates where heat up times are minimized due
to higher ambient temperatures. In either of these modes, the water
temperature is regulated by the set temperature, low-speed pump, and
heater only while a programmed filtration/heating cycle is running. Note:
these modes can be used to conserve energy while on vacation or out
of town for several weeks since heater operation is minimized. During
such times, you can also minimize the spa set temperature to maximize
energy savings!

10.4 Lock Modes - All Models (L1 - L2)

These modes are designed for use during spa service or to prevent unau-
thorized use.

10.5 Selecting The Filtration/Heating Mode

Press and hold both control panel WARMER ( + ) and
COOLER ( - ) buttons at the same time, then release. Then
press either WARMER ( + ) or COOLER ( - ) button to select
either filtration/heating mode or lock mode as outlined on pages 23
or 24.
Page 22