Sundance Spas Altamar Owner's Manual page 25

13. Consult your authorized Sundance dealer for chemical recommen-
dations, then add chemicals to hot tub water to achieve a constant
sanitizer reading within the levels recommended by the Association
of Pool And Spa Professionals printed on the inside cover of this
manual.
14. Turn on all jet pumps and the blower when adding chemicals to
ensure proper mixing and leave your hot tub cover open until the
sanitizer level falls below 4.0 ppm to protect pillows and plastic
knobs from chemical attack.
CAUTION: Never leave your hot tub unattended for any
reason while the cover is open and accessible to small
children and animals!
CAUTION: To prevent the unlikely possibility of contracting
a waterborne illness, maintain water chemistry within step 6
parameters. If you or other bathers experience such a
condition, discontinue use and seek medical attention.
15. Establish a sanitizer reading between 3.0-4.0 ppm Chlorine or 2.0-
4.0 ppm Bromine , then allow the hot tub to set undisturbed for 8
hours. Retest water after 8 hours to determine if sanitizer levels are
stable. If sanitizer levels are stable, your hot tub is ready for use.
To ensure healthy water conditions, always maintain a constant
sanitizer reading within the levels recommended by the Association
of Pool And Spa Professionals printed on the inside cover of this
manual. If sanitizer levels are not stable at this time, it will be neces-
sary to repeat this procedure in its entirety (steps 1-15) until stable
sanitizer readings are achieved.
Page 19