Gateway MG1 Service Manual page 119

2
If the notebook has wireless networking built in, unplug the wireless antennas by
following the steps in
3
Remove the hard drive by following the steps in
page 69.
4
Remove the keyboard cover by following the steps in
cover" on page 76.
5
Remove the keyboard by following the steps in
page 79.
6
Remove the LCD assembly by following the steps in
on page 91.
7
Remove the palm rest by following the steps in
page 104.
8
Remove the touchpad board by following the steps in
board" on page 108.
9
Remove the screws from the touchpad button board bracket.
Screw
10
Swing the black fingerprint reader connector clip upward, then lift the cable out of
the connector. Be careful not to touch or damage any other components.
Touchpad
connector
Fingerprint
reader
connector
Touchpad
button
board
connector
www.gateway.com
"Replacing the IEEE 802.11 wireless card" on page
Screw
"Replacing the hard drive" on
"Replacing the keyboard
"Replacing the keyboard" on
"Replacing the LCD assembly"
"Replacing the palm rest" on
"Replacing the touchpad
63.
113