Init Data; Table 3-1 Unit Data - Carrier VECTOR 6500 Operation & Service Manual

3.13 UNIT DATA
HEAT COOL
-20.0
SETPOINT
PRESS ↑ ↓ TO VIEW DATA
3. The selected Data Item will remain in the MessageCenter for ten seconds, then the de-
fault message ("STATUS OK" or other customer specified message) will display.
4. To lock an item in the MessageCenter for continuous viewing, press the = key. The Data
item will flash continuously to indicate it is locked.
5. Pressing the UP or DOWN ARROW key will unlock that item and move to the next
data item. Pressing the = key will unlock the item and, after ten seconds, the de-
fault message will be displayed.
* Displays information or setting entered in the microprocessor Configurations
+ May or may not be displayed depending on Parameter/Configuration settings
Data readings are presented starting with "SUCTION PRESSURE" and progress-
DATA
SUCTION PRESSURE
DISCHARGE PRESSURE
EVAPORATOR PRESSURE Leaving evaporator pressure
ENGINE COOLANT TEMP
RETURN AIR TEMP
DEFROST ALARM
+34.5 F
BOX TEMPERATURE
MANUAL
ALARM LIST
DEFROST
1. Press the SELECT key until the MessageCenter displays
"PRESS ↑↓ TO VIEW DATA."
2. Press the green UP ARROW key. The MessageCenter will display "PRESS
↑↓ TO VIEW DATA, THEN = TO LOCK" . Continue to press the green UP
ARROW key to move down the Data List, or press the DOWN ARROW key
to move up the Data List. (Refer to Table 3-1.)

Table 3-1 Unit Data

ing down the list using the green UP ARROW key.
Compressor suction pressure
Compressor discharge pressure
Engine coolant temperature
Return (air entering evaporator) temperature
START‐STOP CONTINUOUS
SELECT
START‐STOP/
CONTINUOUS
DEFINITION
3−17
62-11389