Table 8−1 Maintenance Schedule - Carrier VECTOR 6500 Operation & Service Manual

System
a. Pre Trip Inspections
1 Pre Trip Inspection - before starting
2 Pre Trip Inspection - after starting
3 Run Microprocessor Pretrip - Before loading
4 Check Engine Hours
b. Every Service Interval or Yearly
Engine 1 Check engine oil and filter change interval (refer to
Section e. of this table)
2 Check low oil pressure switch
3 Clean crankcase breather
4 Check engine speeds
5 Check water pump belt
Fuel System 1 Clean mechanical and electric (if equipped) fuel pump screens
2 Change fuel filter
3 Check fuel heater (if equipped)
Cooling 1 Check coolant change interval (refer to Section f. of this table).
System If replacement is not required, check antifreeze concentration
using a refractometer (Carrier Transicold part number
07-00435-00)
2 Clean condenser & radiator surfaces
3 Check water pump
4 Check water temperature sensor
Exhaust 1 Check mounting hardware
System 2 Check muffler and exhaust pipes
Air Intake 1 Change air cleaner filter element
System 2 Check and reset air cleaner indicator (if equipped)
Starting 1 Clean battery connections and cable ends
Circuit 2 Check battery hold down clamps
3 Check battery condition
4 Check starter operation
Charging 1 Check battery charger output voltage
Circuit 2 Check battery charger amperage
A.C. 1 Check voltage output
Generator 2 Check amperage output
Unit 1 Check unit mounting bolts
2 Check engine and compressor mounting bolts
3 Check door latches & hinges
4 Check unit switches and electrical connections
5 Check all electrical ground connections
6 Check control box condition
62-11389
Table 8−1 Maintenance Schedule
Operation
8−2
Reference
Section
8.3
8.3
3.4
3.14
Section e.
Check
8.5.14
Table 2-1
Check
8.5.3 & 8.5.4
8.5.5
8.5.7
8.5.12
8.5.12
Check
Check
Check
Check
8.5.9
Check
Check/Replace
Check/Replace
Check
Check
2.11
2.11
2.11
2.11
Check
Check
8.4.3
Check
Check
Check