Headlight Aiming Adjustment; Adjustment After Headlight Assembly Replacement - Hyundai 2001 Santa Fe Owner's Manual

Replace the headlight if damaged or cracked. Replace the headlight if damaged or cracked. Replace the headlight if damaged or cracked. Replace the headlight if damaged or cracked. Replace the headlight if damaged or cracked.
Keep the bulb out of the reach Keep the bulb out of the reach
Keep the bulb out of the reach Keep the bulb out of the reach of children Keep the bulb out of the reach
and dispose of the used bulb with care. and dispose of the used bulb with care. and dispose of the used bulb with care.
and dispose of the used bulb with care. and dispose of the used bulb with care.
G290A01O-AAT

HEADLIGHT AIMING ADJUSTMENT

HEADLIGHT AIMING ADJUSTMENT HEADLIGHT AIMING ADJUSTMENT HEADLIGHT AIMING ADJUSTMENT HEADLIGHT AIMING ADJUSTMENT
Vertical
aiming
Before performing aiming adjustment, make sure
of the following.
1. Keep all tires inflated to the correct pres-
sure.
2. Place the vehicle on level ground and press
the front bumper & rear bumper down sev-
eral times.
Place vehicle at a distance of 118.1 in. (3m)
from the test wall.
3. See that the vehicle is unloaded (except for
full levels of coolant, engine oil and fuel, and
spare tire, jack, and tools). Have the driver
or equivalent weight placed in driver's seat.
6-18
DO-IT-YOURSELF MAINTENANCE DO-IT-YOURSELF MAINTENANCE DO-IT-YOURSELF MAINTENANCE DO-IT-YOURSELF MAINTENANCE DO-IT-YOURSELF MAINTENANCE
4. Clean the head lights lens and turn on the
of children of children
of children of children headlight (Low beam).
5. Open the hood.
6. Draw the vertical line (through the center of
each headlight beam pattern) and the hori-
zontal line (through the center of each head-
light beam pattern) on the aiming screen.
1) Horizontal line dimension from ground:
2WD : 32.5 in.(822 mm)
4WD : 33.3 in.(843 mm)
2) Distance between each vertical line:
46.5 in.(1,178 mm)
And then, draw the parallel line at 0.8 in. (21
mm) under the horizontal line.
7. Adjust each cut-off line of the low beam to
the parallel line with a phillips screwdriver -
VERTICAL AIMING
WARNING: WARNING: WARNING: WARNING: WARNING:
G290A01O
Horizontal aiming should not be adjusted by Horizontal aiming should not be adjusted by Horizontal aiming should not be adjusted by Horizontal aiming should not be adjusted by Horizontal aiming should not be adjusted by
a driver. a driver. a driver. a driver. a driver.
G290B01Y-AAT
Adjustment After Headlight Assembly Adjustment After Headlight Assembly
Adjustment After Headlight Assembly Adjustment After Headlight Assembly Adjustment After Headlight Assembly
Replacement Replacement Replacement
Replacement Replacement
Horizontal line
Cut off
line
L
H
If the vehicle has had front body repair and the
headlight assembly has been replaced, the
headlight aiming should be checked using the
aiming chart as shown in the illustration. Turn
on the headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of light is
parallel to center line of the body and is
aligned with point "P" shown in the illustra-
tion.
2. Dotted lines in the illustration show center of
headlights.
Vertical
line
w
"P"
H
Ground line
G290A03O