Table of Contents
Advertisement
B560A02S-AAT
REMOTE FUEL-FILLER LID RELEASE
The fuel-filler lid may be opened from inside
the vehicle by pulling up on the fuel-filler lid
opener located on the front floor area on the
left side of the car.
NOTE:
If the fuel-filler lid will not open because
ice has formed around it, tap lightly or
push on the lid to break the ice and release
the lid. Do not pry on the lid. If necessary,
spray around the lid with an approved de-
icer fluid (do not use radiator anti-freeze)
or move the vehicle to a warm place and
allow the ice to melt.
FEATURES OF YOUR HYUNDAI
WARNING:
B560A01O
o The fuel cap must be tightened at least
3 clicks, otherwise "
illuminate.
o Gasoline vapors are dangerous. Before
refueling, always stop the engine and
never allow sparks or open flames near
the filler area. If you need to replace the
filler cap, use a genuine Hyundai re-
placement part.
o If you open the fuel filler cap during
high ambient temperatures, a slight
"pressure sound" may be heard. This is
normal and not a cause for concern.
Whenever you open the fuel filler cap,
turn it slowly.
o Make sure the fuel filler cap is replaced
and securely seated after fueling. Fail-
ure to replace or fully seat the fuel filler
cap will result in fuel vapors escaping
into the atmosphere and the check en-
gine "MIL" indicator illuminating.
o Do not "TOP-OFF" after the first nozzle
shut off when refueling.
B570A01A-AAT
HOOD RELEASE
B560A02O
" light will
1. Pull the release knob to unlatch the hood.
2. Press the secondary catch lever up and lift
the hood.
3. Hold the hood open with the support rod.
Before closing the hood, return the support
rod to its clip to prevent it from rattling. Lower
the hood until it is about 1 ft. (30 cm) above
the closed position and let it drop. Make sure
that it locks into place.
B570A01O
1- 41
Advertisement
Table of Contents
