Table of Contents
Advertisement
H290B02O-GAT
1. POWER ON-OFF Control Knob
The radio unit may be operated when the
ignition key is in the "ACC" or "ON" position.
Press the button to switch the power on. The
display shows the radio frequency in the radio
mode or the tape direction indicator in the
tape mode, or CD track indicator in the CD
mode. To switch the power off, press the
button again.
VOLUME Control
Rotate the knob clockwise to increase the
volume and turn the knob counterclockwise to
reduce the volume.
2. BASS/BALANCE Control Knob
BASS Control Knob
Press to pop the knob out. To increase the
bass, rotate the knob clockwise, while to
decrease the bass, rotate the knob counter-
clockwise.
BALANCE Control knob
Pull the bass control knob out further. Rotate
the knob clockwise to emphasize right speaker
sound. (Left speaker sound will be attenu-
ated) When the control knob is turned coun-
terclockwise, left speaker sound will be em-
phasized (Right speaker sound will be attenu-
ated).
1- 60
FEATURES OF YOUR HYUNDAI
3. TREBLE/FAD Knob
TREBLE Control Knob
Press to pop the knob out and turn to the left
or right for the desired treble tone.
FAD (Fader Control) Knob
Pull the treble control knob out further. Turn
the control knob counterclockwise to empha-
size front speaker sound. (Rear speaker sound
will be attenuated) When the control knob is
turned clockwise, rear speaker sound will be
emphasized. (Front speaker sound will be
attenuated)
4. TUNE (Manual) Select Button
Press the ( ) side or ( ) side to increase or
to decrease the frequency. Press either but-
ton and hold down to continuously scroll.
Release button once the desired station is
reached.
SEEK Operation (Automatic Channel
Selection)
Press the TUNE select button for 0.5 sec or
more, and releasing will automatically tune
the next available station with beep sound.
When the ( ) side is pressed longer than 0.5
second and releasing will automatically tune
the next higher frequency and when the (
side is pressed longer than 0.5 second and
releasing will automatically tune the next lower
frequency.
5. PRESET STATION Select Buttons
Six (6) stations for AM, FM and FM2 respec-
tively can be preset in the electronic memory
circuit.
HOW TO PRESET STATIONS
Six AM and twelve FM stations may be pro-
grammed into the memory of the radio. Then,
by simply pressing the band select button
and/or one of the six station select buttons,
you may recall any of these stations instantly.
To program the stations, follow these steps:
o Press band selector to set the band for
AM, FM or FM2.
o Select the desired station to be stored by
seek or manual tuning.
o Determine the preset station select button
you wish to use to access that station.
o Press the station select button for more
than two seconds. A select button indicator
will show in the display indicating which
select button you have depressed. The
frequency display will flash after it has
been stored into the memory with beep
sound. You should then release the but-
ton, and proceed to program the next de-
sired station. A total of 18 stations can be
programmed by selecting one AM and two
FM station per button.
)
o When completed, any preset station may
be recalled by selecting AM, FM or FM2
band and the appropriate station button.
Advertisement
Table of Contents
